Controller Supply-HM-V1-T

Controller Supply-HM-V1-T

RF remote, 0/1-10V, Push Dim (3-in-1) Triac Dimmer.
4096 razinama 0-100% dimming smoothly without any flflash.
Match with RF 2.4G single zone or multiple zone dimming remote control.

One RF controller accept up to 10 remote control.
Auto-transmitting function: Controller automatically transmit signal to another controller with 15m control distance.

Synchronize on multiple number of controllers.
Connect with external push switch to achieve on/off and 0-100% dimming function.

Light on/off fade time 3s selectable.
Over-heat / Over-load / Short circuit protection, recover automatically

Pošaljite nam e-poštu Kontaktirajte sada Preuzmite kao PDF

Pojedinosti o proizvodu Povratne informacije sada

Inpuf and Oufput
Input voliage	12-24VDC
Input current	20.5A
Output voltage	12-24VDC
Output current	1CH,20A
Output power	240W/480W (12V/24V)
Ouput ype	Constant volage

Dimming data
Input signal	RF 2.4GHz 0/1-10V Push Dim
Control distance	15m(Barrier-free space)
Dimming gray scale	4096(2^12)razinama
Raspon zatamnjivanja	0 -100%
Dimming curve	Logarithmic
PWM Frequency	500Hz(default)

Sigurnost i EMC
EMC standard (EMC)	ETSI EN 301 489-1 V2.2.3 ETSI EN 301 489-17 V3.2.4
Sigurnosni standard(LVD	U 62368-1:2020+A11:2020
Radio oprema(CRVENA)	ETSI EN 300 328 V2.2.2
Certifikacija	OVAJ,EMC,LVD,CRVENA

Okoliš
Radna temperatura	Ta: -30°C ~ +55°C
Case temperature (Max.)	T c:+85°C
IP ocjena	IP20

Warranty and Protection

Jamstvo

5 godine

Protection

Reverse polarity

Over-heat

Over-load

LED napajanje

Težina
Neto težina	0.234kg
Bruto težina	0.054kg

Mechanical Structures and Installations

Wiring Diagram

Note: The RF remote, 0/1-10V dimmer or Push switch can be connected at the same time,

which makes the product more user-friendly and more options to fit for some extra-ordinary demands.

Match Remote Control (two match ways)

End user can choose the suitable match/delete ways. Two options are offered for selection:

Use the controller’s Match key

Match:

Short press match key, immediately press on/off key (single zone remote) or zone key (multiple zone remote) of the remote. The LED indicator fast flash a few times means match is successful.

Delete:
Press and hold match key for 5s to delete all match, The LED indicator fast flash a few times means all matched remotes were deleted.

Use Power Restart

Match:
Switch off the power, then switch on power, repeat again. Immediately short press on/off key (single zone remote) or zone key (multiple zone remote) 3 times quickly. The light blinks 3 times means match is successful.

Delete:
Switch off the power, then switch on power, repeat again. Immediately short press on/off key (single zone remote) or zone key (multiple zone remote) 5 times quickly. The light blinks 5 times means all matched remotes were deleted.

0/1-10V Dimming

The 0/1-10V input is operable via commercially available simple rotary wall switchs designed for 0/1-10V dimming equipment or from decicated system central dimming controllers.

Compliant with 0-10V, 1-10V, 10V PWM, RX(4 u 1).
We recommend the number of LED drivers connected to 0/1-10V dimmer does not exceed 5 pieces,The maximum length of the wires from dimmer to LED driver should be no more than 15 metara.

If the controller be used with the RF remote or Push-Dim interface prior to using the 0/1-10V interface,the 0/1-10 V signal should change over 10% to return 0/1-10 V control.

Push Dim Function

The provided Push-Dim interface allows for a simple dimming method using commercially available non-latching (momentary) wall switchs.

Short press:

Turn on or off light.

Long press (1-6s):

Press and hold to step-less dimming,

With every other long press, the light level goes to the opposite direction.

Dimming memory:

Light returns to the previous dimming level when switched off and on again, even at power failure.

Synchronization:

If more than one controller are connected to the same push switch, do a long press for more than 10s,

then the system is synchronized and all lights in the group dim up to 100%.

This means there is no need for any additional synchrony wire in larger installations.

We recommend the number of controllers connected to a push switch does not exceed 25 pieces,

The maximum length of the wires from push to controller should be no more than 20 metara.

Dimming Curve

Light on/off fade time

Long press match key 5s, then short press match key 3 puta, the light on/off time will be set to 3s, the indicator light blink 3 puta. Light on/off fade time Long press match key 10s, restore factory default parameter, the light on/off time also restore to 0.5s.

Malfunctions Analysis & Troubleshooting

Malfunctions	Causes	Troubleshooting
No light	1. No power. 2.Wrong connection or insecure.	1.Check the power. 2.Check the connection.
Uneven intensity between front and rear,with voltage drop	1. Output cable is too long. 2. Wire diameter is too small. 3.Overload beyond power supply capability. 4.Overload beyond controller capability.	1.Reduce cable or loop supply. 2.Change wider wire. 3.Replace higher power supply. 4.Add power repeater.
No response from the remote	1.The battery has no power. 2. Beyond controllable distance. 3.The controller did not match the remote.	1. Replace battery. 2.Reduce remote distance. 3. Re-match the remote.

Controller Supply-HM-V1-T-

Q1. Je li u redu za OEM i ODM ?

Osvjetljenje oklopa profesionalno je za OEM i ODM narudžbe. Imamo bogato iskustvo u procesu proizvodnje i osiguravanju dobre kvalitete.

Q2.Koji je MOQ? Mogu li dobiti neke uzorke ?

Niska MOQ, 1 kom za provjeru kvalitete uzoraka je dostupna. Narudžba uzoraka je prihvatljiva i dobrodošli su prilagođeni uzorci za vaš projekt.

Q3. Koliko dugo traje vrijeme isporuke?

Potrebe uzorka 3-5 dana, količina narudžbe treba 10-15 dana

Q4. Kako šaljete robu i koliko vremena treba da stigne?

Obično isporučujemo DHL-om, UPS, FedEx ili TNT. Obično traje 3-5 dana do dolaska. Zračna i pomorska dostava također neobavezna.

P5. Kako nastaviti s narudžbom za prilagođeno svjetlo ?

Prvi, javite nam vaše zahtjeve ili crtež.Drugo, citiramo prema vašim zahtjevima.Treće, potvrđujete i dogovarate uplatu za formalnu narudžbu.Konačno, pokrenut ćemo proizvodnju i dogovoriti otpremu.

Q6. Koliko dugo traje jamstvo?

Svi Armor proizvodi za osvjetljenje kvalitete su 3 godine, lf prilagođeni projektni proizvodi s 5 godina jamstva.

P7. Je li u redu ispisati svoj LoGo na proizvod ?

Da, molimo vas da nas formalno obavijestite prije proizvodnje i prvo potvrdite dizajn na temelju našeg uzorka.

P8. Kako se nositi s neispravnim?

Nudimo 2, 3 i 5 godišnje ograničeno jamstvo za različite vrste proizvoda ili različite zahtjeve projekata rasvjete. Tijekom ovog perioda, ako kupci imaju probleme s kvalitetom dokaza i taj dokaz su odobrili inženjeri oklopne rasvjete, željeli bismo zamijeniti neispravne s novim kvalificiranim artiklima.

Imajte na umu da jamstvo nije jednako životnom vijeku. Naši proizvodi imaju više od 50000 sati životnog vijeka.

Q9. Mogu li posjetiti vašu tvornicu?

Naravno,dobrodošli u posjet našoj tvornici. Can nam daje do znanja vaš raspored posjeta prije dva dana i vaše zainteresirane proizvode.

Q10.Jeste li tvornica ili trgovačko poduzeće?

Mi smo tvornica izravno izvoz na more preko tržišta.

Q11.Dobavljate li led rasvjetu bilo kojoj poznatoj robnoj kući Lighting?

Da,naša LED trgovina Lighting je opskrbljivala LANCOME , LEGO,SLJEDEĆI,TRENER, Burtova pčela,Hasbro, Čizme，BRAUN,M&S itd.