×
Controller Supply-HM-V1-T
Controller Supply-HM-V1-T
  • RF remote, 0/1-10V, Push Dim (3-in-1) poipoila.
  • 4096 levels 0-100% dimming smoothly without any flflash.
  • Match with RF 2.4G single zone or multiple zone dimming remote control.
  • One RF controller accept up to 10 remote control.
  • Auto-transmitting function: Controller automatically transmit signal to another controller with 15m control distance.
  • Synchronize on multiple number of controllers.
  • Connect with external push switch to achieve on/off and 0-100% dimming function.
  • Light on/off fade time 3s selectable.
  • Over-heat / Over-load / Short circuit protection, recover automatically
Fakaikiiki ʻo e koloa Fakamatala he taimi ni

 

 

 

Inpuf and Oufput
Input voliage 12-24VDC
Input current 20.5Ko ha
Output voltage 12-24VDC
Output current 1CH,20Ko ha
Output power 240W/480W

(12V/24V)

Ouput ype Constant volage

 

Dimming data
Input signal RF 2.4GHz

0/1-10V

Push Dim

Control distance 15m(Barrier-free space)
Dimming gray scale 4096(2^12)levels
Dimming range 0 -100%
Dimming curve Logarithmic
PWM Frequency 500Hz(default)

 

 

Safety and EMC
EMC standard (EMC) ETSI EN 301 489-1 V2.2.3

ETSI EN 301 489-17 V3.2.4

Safety standard(LVD EN 62368-1:2020+A11:2020
Radio Equipment(RED) ETSI EN 300 328 V2.2.2
Certification CE,EMC,LVD,RED

 

 

Environment
Operation temperature Ta: -30°C ~ +55°C
Case temperature (Max.) T c:+85°C
Faʻahinga ʻo e IP IP20

 

 

Warranty and Protection
Warranty 5 ngaahi taʻu
Protection Reverse polarity

Over-heat

Over-load

Short circuit

 

 

Weight
Net weight 0.234kg
Gross weight 0.054kg

 

 

 

 

 

Mechanical Structures and Installations

 

 

 

Wiring Diagram

 

 

 

 

 

Note: The RF remote, 0/1-10V dimmer or Push switch can be connected at the same time,

which makes the product more user-friendly and more options to fit for some extra-ordinary demands.

 

 

Match Remote Control (two match ways)

 

End user can choose the suitable match/delete ways. Two options are offered for selection:

 

Use the controller’s Match key

Match:

Short press match key, immediately press on/off key (single zone remote) or zone key (multiple zone remote) of the remote. The LED indicator fast flash a few times means match is successful.

Delete:
Press and hold match key for 5s to delete all match, The LED indicator fast flash a few times means all matched remotes were deleted.

Use Power Restart

Match:
Switch off the power, then switch on power, repeat again. Immediately short press on/off key (single zone remote) or zone key (multiple zone remote) 3 times quickly. The light blinks 3 times means match is successful.

Delete:
Switch off the power, then switch on power, repeat again. Immediately short press on/off key (single zone remote) or zone key (multiple zone remote) 5 times quickly. The light blinks 5 times means all matched remotes were deleted.

 

0/1-10V Dimming

  • The 0/1-10V input is operable via commercially available simple rotary wall switchs designed for 0/1-10V dimming equipment or from decicated system central dimming controllers.
  • Compliant with 0-10V, 1-10V, 10V PWM, RX(4 in 1).
  • We recommend the number of LED drivers connected to 0/1-10V dimmer does not exceed 5 pieces,The maximum length of the wires from dimmer to LED driver should be no more than 15 meters.
  • If the controller be used with the RF remote or Push-Dim interface prior to using the 0/1-10V interface,the 0/1-10 V signal should change over 10% to return 0/1-10 V control.

 

Push Dim Function

The provided Push-Dim interface allows for a simple dimming method using commercially available non-latching (momentary) wall switchs.

  • Short press:

Turn on or off light.

  • Long press (1-6s):

Press and hold to step-less dimming,

With every other long press, the light level goes to the opposite direction.

  • Dimming memory:

Light returns to the previous dimming level when switched off and on again, even at power failure.

  • Synchronization:

If more than one controller are connected to the same push switch, do a long press for more than 10s,

then the system is synchronized and all lights in the group dim up to 100%.

This means there is no need for any additional synchrony wire in larger installations.

We recommend the number of controllers connected to a push switch does not exceed 25 pieces,

The maximum length of the wires from push to controller should be no more than 20 meters.

 

Dimming Curve

 

 

 

Light on/off fade time

 

Long press match key 5s, then short press match key 3 times, the light on/off time will be set to 3s, the indicator light blink 3 times. Light on/off fade time Long press match key 10s, restore factory default parameter, the light on/off time also restore to 0.5s.

 

 

Malfunctions Analysis & Troubleshooting

 

Malfunctions Causes Troubleshooting
No light 1. No power.

2.Wrong connection or insecure.

1.Check the power.

2.Check the connection.

Uneven intensity between front and rear,with voltage drop 1. Output cable is too long.

2. Wire diameter is too small.

3.Overload beyond power supply capability.

4.Overload beyond controller capability.

1.Reduce cable or loop supply.

2.Change wider wire.

3.Replace higher power supply.

4.Add power repeater.

No response from the remote 1.The battery has no power.

2. Beyond controllable distance.

3.The controller did not match the remote.

1. Replace battery.

2.Reduce remote distance.

3. Re-match the remote.

 

 

Controller Supply-HM-V1-T-

Controller Supply-HM-V1-T-

 

Controller Supply-HM-V1-T-

 

Controller Supply-HM-V1-T-

 

Controller Supply-HM-V1-T-

Q1.ls ʻoku sai pe ia kia OMO ODM ?

ʻOku fakapalofesinale ʻa e maama ʻo e teunga tau ki he OMO e ODM Order. ʻOku tau aʻusia ha taukei lahi ke tokoni ki he faiva pea fakapapauʻi ʻa e tuʻunga lelei.

 

Q2. Ko e ha ʻa e MOQ? ʻE lava ke ʻi ai ha ngaahi sipinga ʻo e l ?

Maʻulalo MOQ, 1 ʻOku lava ke maʻu ʻa e sipinga ʻo e ngaahi sipinga ʻo e sieke ʻoku lava ke maʻu pea talitali lelei ʻa e ngaahi sipinga fakapatonu ki hoʻo ngaue.

 

Q3. Ko e ha hono fuoloa ʻo e taimi taki?

Sīpinga ʻo e ngaahi fie maʻ 3-5 ngaahi ʻahó, fie maʻu e lahi ʻo e ʻota 10-15ʻaho

 

Q4. ʻOku ke ʻave fefe ʻa e ngaahi koloa pea ko e ha hono fuoloa pea toki aʻu mai?

ʻOku tau faʻa ʻave ʻa e DHL, FAKAMALOHISINO, FedEx pe TNT. ʻOku faʻa fie maʻu ʻe he lt 3-5 ngaahi ʻaho ke aʻu mai ai. ʻOku toe fili pe foki ʻa e vaka vakapuna mo e tahi.

 

Q5. Founga ke hoko atu ai ha ʻota ki fakapatonu maama ?

ʻUluaki, ʻai ke mau ʻiloʻi hoʻo ngaahi fie maʻu pe ta fakatataa. Ua, ʻoku mau lau atu ʻo fakatatau ki hoʻomou ngaahi fie maʻu. Tolu, ʻoku ke fakapapauʻi mo fokotuʻutuʻu ʻa e totongi ki he ʻota totonu. Fakaʻosi, te tau fokotuʻutuʻu ʻa e faiva pea fokotuʻutuʻu ʻa e uta.

 

Q6. Ko e ha hono fuoloa ʻo e maluʻi?

Ko e tuʻunga lelei kotoa ʻo e mama ʻoku ʻi ai e teunga tau 3 ngaahi taʻu, lf fakapatonu e ngaue mo e maluʻi taʻu ʻe 5.

 

Q7.ls ʻoku sai pe ke paaki ʻeku LoGo ʻi he koloa ?

ʻIo, Kataki ʻo fakaha mai kiate kimautolu kimuʻa pea toki fokotuʻu pea fakapapauʻi ʻa e palani firstly basedon ʻetau sipinga.

 

Q8. Founga ke fehangahangai ai mo e halaia?

ʻOku mau ʻoatu 2, 3 mo e 5 maluʻi fakangatangata ʻo e taʻu ki he faʻahinga kehekehe ʻo e koloa pe differentrequirements ʻo e ngaahi ngaue mama. Lolotonga e vahaʻataimi ko ʻení, Kapau ʻoku maʻu ʻe he kau fakatau ʻa e ngaahi meʻa proofshowing lelei pea ʻoku fakangofua ʻa e fakamoʻoni ko ia ʻe he kau ʻenisinia ʻo e teunga tau, ʻOku mau fie fetongi ʻa e ngaahi maumau ʻaki ha ngaahi meʻa foʻou ʻoku feʻunga.

Kataki ʻo fakatokangaʻi ange ʻoku ʻikai tatau ʻa e maluʻi mo e lifespan. ʻOku laka hake ʻi he houa ʻe 50000 ʻetau koloa lifespan.

 

Q9. ʻE lava ke u ʻaʻahi ki ho fale ngaohiʻanga?

ʻIo,talitali lelei ke ʻaʻahi ki homau fale ngaohiʻanga. Te ne lava ʻo ʻai ke tau ʻiloʻi hoʻo taimi-tepile ʻaʻahi kimuʻa ʻi ha daysand ʻe ua kimuʻa pea ke saiʻia ai.

 

Q10. ʻOku ke fale ngaohiʻanga pe kautaha fefakatauʻaki?

ʻOku tau hiki fakahangatonu atu ki he maketi ʻi he tahi.

 

Q11.Do ke taki ʻa e mama ki ha faʻahinga falekoloa ʻiloa?

ʻIo,Naʻe maʻu ʻe heʻemau falekoloa ʻa e mama ki LANCOME , KO E ʻALU ʻA LE,HOKO,FAIAKO, Hone ʻo Sinuasi Peeti mei,Hasbro, Puti,BRAUN,M&S mo e ala meʻa pehe.

 

 

 

ʻAve hoʻo popoaki kiate kimautolu:
FEHUʻI HE TAIMI NI
FEHUʻI HE TAIMI NI